Canmore Synthetic Suede/Leather Zip Pipe Bag
The Canmore Synthetic Suede/Leather Zip Pipe Bag is a synthetic suede/leather pipe bag with a side zip. It has been created to give the feel of a hide pipe bag whilst having the convenience of a synthetic pipe bag.
The Canmore Pipe Bag comes fitted with an Airtight Zip. It also includes a small tube of Zip Lubricant for the Zip, 5 pieces of Amalgamating Tape and an 'O'Ring and Hose Clamp to secure the Chanter Stock.
Available in 5 sizes:- Small, Extended Small, Medium, Extended Medium & Large
Small 667mm x 241mm (26.25" x 9.5")
Extended Small 692mm x 241mm (27.25" x 9.5")
Medium 692mm x 260mm (27.25" x 10.25")
Extended Medium 718mm x 260mm (28.25" x 10.25")
Large 718mm x 279mm (28.25" x 11")
Fitting Instructions
Start off by installing the 3 Drone Stocks. Simply push them up through the Stock Holders from the inside of the bag until the bottom of the stock becomes just short of flush with the bottom of the Stock Holder. Then install the Blowpipe Stock in the same way.
The Chanter Stock is installed by inserting it into the bag and placing the 'O' Ring over the stock and bag, so the 'O' Ring fits into the tie-in recess on the stock. Then place the hose clamp over the 'O' Ring and tighten the hose clamp firmly, using a screw driver. As the hose clamp tightens it, keep it centred so it compresses the 'O' Ring to create an airtight fit.
Once all the stocks are in place, it is time to apply the Amalgamating Tape to help hold each stock in place and to create a perfect seal between the stock and stock holder. The amalgamating tape comes in short pieces but stretches out incredibly to form a skin like consistency. It sticks to, and also amalgamates with itself to almost form one piece. Peel the backing tape off about 20mm and then use your thumb to hold it in position to start. Apply whilst stretching it out at the same time. Each piece should go around the stock several times. If it snaps just stick it on again and continue. Once you come close to the end of the piece stretch it until it snaps and this will stick to the end.
The Canmore Zip Bag is now completely fitted. Test the bag for airtightness before putting the pipes back together.
If the Zip becomes dry, it is necessary to lubricate it using the tube of lubricant supplied. Lightly lubricate the teeth of the whole length of the zip. There are also 2 little indents at the end of the zip where a very small amount of the lubricant should be applied. The zip pull carries the lubricant across the zip itself each time that it is opened and closed. Each time the zip is closed, make sure that it is locked securely in place.
To Order Now:- sales@lyonsbagpipes.com
Website Created and Managed by Lyons Bagpipes & Highland Supplies©